Posology
Adults (including the older people)
AK, BCC and Bowen's disease using red light
For treatment of actinic keratoses (AK) one session of photodynamic therapy should be administered. Treated lesions should be evaluated after three months and if there has been an incomplete response, a second treatment may be given. For treatment of basal cell carcinoma (BCC) and Bowen's disease two sessions should be administered with an interval of one week between sessions. Before applying Metvix, the lesion surface should be prepared to remove scales and crusts and roughen the surface of the lesions. Nodular BCC lesions are often covered by an intact epidermal keratin layer which should be removed. Exposed tumour material should be removed gently without any attempt to excise beyond the tumour margins.
AK using daylight
The daylight treatment may be used to treat mild to moderate AK lesions. One treatment should be given. Treated lesions should be evaluated after three months and if there has been an incomplete response, a second treatment may be given.
Paediatric population
The safety and efficacy of Metvix in children below 18 years have not yet been established.
Method of administration
Treatment of AK lesions and/or field cancerization, BCC and Bowen's disease using red-light lamp:
a) Preparation of the lesions: Scales and crusts should be removed, and the skin surface roughened before applying a thin layer of Metvix to the lesion(s). Using a spatula, apply a layer of Metvix (about 1 mm thick) to the lesion area (for field cancerization up to 20 cm2, approximately) and approximately 5-10 mm of the surrounding area. Cover the treated area with an occlusive dressing for 3 hours. Remove the dressing and clean the area with saline.
b) Illumination: Immediately after cleaning the lesions, the entire treatment area will be illuminated with a red-light source, either with a narrow spectrum around 630 nm and a light dose of approximately 37 J/cm2 or a broader and continuous spectrum in a range between 570- and 670 nm with a light dose of approximately 75 J/cm². The light intensity at the lesion surface should not exceed 200 mW/cm2.Only CE marked lamps should be used, equipped with necessary filters and/or reflecting mirrors to minimize exposure to heat, blue light and UV radiation. It is important to ensure that the correct light dose is administered. The light dose is determined by factors such as the size of the light field, the distance between lamp and skin surface and illumination time. These factors vary with lamp type, and the lamp should be used according to the user manual. The light dose delivered should be monitored if a suitable detector is available. Patient and operator should adhere to safety instructions provided with the light source. During illumination patient and operator should wear protective goggles which correspond to the lamp light spectrum. Healthy untreated skin surrounding the lesion does not need to be protected during illumination. Multiple lesions may be treated during the same treatment session.
Lesion responses should be assessed after three months, and at this response evaluation, lesion sites showing non-complete response may be retreated if desired. It is recommended that the response of BCC and Bowen's disease lesions be confirmed by histological examination of biopsy material. Subsequently, close long term clinical monitoring of BCC and Bowen´s disease is recommended, with histology if necessary.
Treatment of AK using lesions and/or field cancerization with natural daylight
|  | a) Considerations before treatment: Metvix natural daylight treatment can be used if the temperature conditions are suitable to stay comfortably outdoors for 2 hours. If the weather is rainy, or is likely to become so, Metvix natural daylight treatment should not be used (see section 5.1). b) Preparation of the lesions: A sunscreen should be applied, please see section 4.4. Once sunscreen has dried, scales and crusts should be removed and the skin surface roughened before applying a thin layer of Metvix to the lesion(s) or field of cancerization. No occlusion is necessary. c) Illumination using daylight for AK treatment: Patients should go outside after Metvix application or, at the latest, 30 minutes later in order to avoid excessive protoporphyrin IX accumulation which would lead to greater pain on light exposure. In order to minimize pain and ensure maximum efficacy the patient should then stay outdoors for 2 continuous hours in full natural daylight and avoid going indoors. On sunny days, should the patient feel uncomfortable in direct sunlight, shelter in the shade may be taken. Following the 2 hour exposure period, Metvix should be washed off. |
Multiple lesions may be treated during the same treatment session
Treated lesions should be evaluated after three months and if there has been an incomplete response, a second treatment may be given.
Treatment of AK lesions and/or field cancerization using artificial daylight device
Preparation of the lesions: Scales and crusts should be removed, and the skin surface roughened before applying a thin layer of Metvix to the areas to be treated.
| | a) Occlusion is not necessary. Sunscreen is not needed, as patients are not exposed to ultraviolet light. |
Illumination using artificial daylight for AK treatment: Lesion should be exposed after Metvix application or, at the latest, 30 minutes later in order to avoid excessive protoporphyrin IX accumulation which would lead to greater pain on light exposure. In order to minimize pain and ensure maximum efficacy, the patient should be exposed to artificial daylight for 2 continuous hours in a comfortable position. Following the 2-hour exposure period, Metvix should be washed off.
Only CE marked devices should be used. The devices should have a continuous light spectrum of 400 to 750 nm and an illuminance greater than 12,000 lux at the lesion surface. It is important to ensure that the correct light dose is administered. The light dose is determined by factors such as the illuminance (or equivalent), the size of the light field, the distance between lamp and skin surface and illumination time. These factors vary with lamp type, and the lamp should be used according to the user manual. Patient and operator should adhere to safety instructions provided with the light source.
| | b) Healthy untreated skin surrounding the lesion does not need to be protected during illumination. Multiple lesions may be treated during the same treatment session |
Lesion responses should be assessed after three months, and at this response evaluation, lesion sites showing incomplete response may be retreated if desired.